Rear bumper harness
Rear bumper harness |
Replace |
1. |
Remove the
rear bumper shell
.
|
2. |
Pull the cellular block loose from the bumper shell tongues.
|
3. |
Unplug the wiring harness connectors from all components.
|
4. |
Carefully remove the wiring harness without damaging cable ties, etc. that are to be refitted.
|
5. |
Lay out the new wiring harness the same as the old one and secure it in the same way.
|
6. |
Plug in the connectors to the respective component. If in doubt, consult the wiring diagram/component list of the system in question.
|
7. |
Fit the cellular block by guiding it onto the bumper shell tongues. Press it into place.
|
8. |
Fit the
rear bumper shell
.
|