Oil cooler pipe
Oil cooler pipe |
To remove |
1. |
Place covers over the wings to keep the paintwork clean and protect it from damage.
|
2. |
Remove the battery cover.
|
3. |
Remove the battery, coolant pipe, main fuse box and bonnet switch.
|
4. |
Unplug the control module connector. Unplug the connectors under the control module. Remove the battery tray.
|
5. |
Remove the dust protector from the upper pipe, turn
87 92 806 Oil pipe quick-release coupling removal tool
slightly and detach the upper connection. Undo the pipe from the clip at the same time. Have a rag ready to catch any oil spill.
|
6. |
Raise the car and place a receptacle underneath.
CV:
Remove
Chassis reinforcement, front subframe, CV
|
7. |
Drain the fluid from the transmission.
|
8. |
Remove the spoiler shield.
|
9. |
Remove the oil pipe from the transmission.
|
10. |
Undo the turbo hose from the turbo pipe and move it aside.
|
11. |
Remove the dust protection and the pipe from the oil cooler. Use
87 92 806 Oil pipe quick-release coupling removal tool
as above.
|
Fitting |
1. |
Change the pipe seals in the transmission. Use
83 90 270 Sliding hammer
,
87 92 319 Adapter 3/8" - M10
and
87 92 756 Oil pipe puller
.
|
2. |
Fit new seals lubricated with Vaseline using
87 92 814 Oil pipe seal fitting tool
. The pipes will penetrate the seals when fitting.
|
3. |
Apply
Vaseline, non-acidic
to the end pieces of the cooling pipes and put the pipe into position.
|
4. |
Fit the lower pipe to the cooler. Press until the pipe snaps into position. Press on the dust protector.
|
5. |
Fit the coolant pipe to the transmission. The pipe will penetrate the seals. The hoses must be above the power steering pipe.
Tightening torque 6 Nm (4 lbf ft) |
6. |
Fit the turbo hose.
|
7. |
Fit the spoiler shield.
CV:
Fit
Chassis reinforcement, front subframe, CV
|
8. |
Lower the car and fit the upper hose to the holder and the oil cooler. Press until the pipe snaps into position. Press on the dust protector.
|
9. |
Plug in the connectors under the control module. Plug in the control module connector and fit the bonnet switch and battery tray.
|
10. |
Fit the cooling pipe, main fuse box and battery. Connect the battery cables.
|
11. |
Fit the battery cover.
|
12. |
Fill with 3 litres of fluid in the transmission. Check the fluid level, see
Checking the transmission fluid level
.
|
13. |
Remove the wing covers.
|
14. |
Carry out
Measures after disconnecting the battery
.
|