Handbrake lever
Handbrake lever |
To remove |
1. |
Remove the floor console
.
|
2. |
Remove the rear air duct.
|
3. |
Loosen the adjustment and unhook the cables.
|
4. |
Remove the cable ferrules from the console.
|
5. |
Mark the position of the front nut.
|
6. |
Remove the bolts and nuts holding the lever mechanism. Lift out the mechanism.
|
To fit |
1. |
Fit the lever and holder to the console. Make sure the front nut is aligned with the marking.
Tightening torque: 13 Nm (10 lbf ft) |
2. |
Connect and adjust the handbrake cables.
|
3. |
Fit the air ducts.
|
4. |
Fit the floor console
.
|
5. |
Adjust the lever height in relation to the centre console by fitting the correct stop washer.
|