Hydraulic unit, TCS/ESP, bracket
|
Hydraulic unit, TCS/ESP, bracket
|
Important
|
ESD-SENSITIVE COMPONENT
|
Earth yourself by touching the car body before plugging in / unplugging components.
Do not touch the component pins
. Read
Before removing a control module
before changing a control module.
|
|
Important
|
Scrupulous cleanliness must always be observed during all work with hydraulic components.
|
|
4.
|
B284 LHD:
Remove the brake servo heat shield (A).
|
5.
|
Unplug the connector (A) from the control module.
Important
|
Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to
Connectors, handling and inspection
.
|
|
|
6.
|
Remove the brake pipes (B) from the unit.
|
7.
|
B284 LHD:
Remove the brake pipes (C) from the master cylinder.
|
8.
|
Remove the bracket (D) from the spring strut tower.
|
10.
|
Remove the bracket (A) from the unit.
|
1.
|
Fit the bracket (A) onto the unit.
Tightening torque: 10 Nm (7.5 lbf ft)
|
2.
|
Put the unit in place with guide pin in the rubber bushing.
|
3.
|
Fit the bracket (D) for the spring strut tower.
Tightening torque 25 Nm (18 lbf ft)
|
4.
|
Attach the brake pipes (B) to the unit.
|
5.
|
B284 LHD:
Fit the brake pipes (C) for the master cylinder.
|
6.
|
Plug in the connector (A) for the control module.
|
7.
|
B284 LHD:
Fit the brake servo heat shield (A).
|
9.
|
Fill with
servo fluid, as specified
.
Important
|
The EHPS system must not be run dry. Do not reuse drained fluid. Fill the hydraulic system with special fluid.
|
|
|
12.
|
Remove the wing cover.
|