Compressor, To remove and To fit, Z18XE
|
Compressor, To remove and To fit, Z18XE
|
Important
|
The A/C receiver and the compressor oil absorb moisture from the air, which can then not be removed. Plug all connections that are opened immediately.
|
|
3.
|
Remove the refrigerant line as follows:
- Unscrew bolt (1)
- Pull away block joint, refrigerant line (2)
|
4.
|
Remove the compressor as follows:
- Unplug the connector (2) - Release and unplug
- Unscrew bolt (1)
- Remove the compressor (3)
Important: Only when replacing the compressor
|
1.
|
Fit the compressor as follows:
- Tighten the bolt (1) (20 Nm)
- Plug in the connector (2)
|
2.
|
Fit the refrigerant line as follows:
- Change the seal (1)
- Attach the refrigerant line (2)
- Tighten the bolt (20 Nm)
|
5.
|
When fitting a new compressor the following running-in instructions must be followed:
|
|
5.1.
|
Open all air vents on the dashboard.
|
|
5.2.
|
Start the car's engine and allow idling speed to stabilise (approx. 5 seconds).
|
|
5.4.
|
Switch on the air conditioning and allow it to run uninterrupted for at least 2 minutes at an engine speed less than 1500 r/min.
|