Pre-delivery service
Pre-delivery service |
The materials required for pre-delivery service are packed in the car's glove box and luggage compartment.
The PDI checklist is available at "Dealerworld".
1. |
Unlock the car.
|
2. |
Remove the
plastic paint protector
.
|
3. |
CV:
Remove the protection from the soft top.
|
4. |
Remove the
transport protection
from the suspension.
|
5. |
Remove the
transport protection from the brake discs
and the label from the windscreen.
|
6. |
Perform
Battery check during pre-delivery service
.
|
7. |
Fit the
battery cover
.
|
8. |
Adjust
tyre pressure
(including the spare tyre, if included).
|
9. |
Cars with steel rims:
Fit the hub caps.
|
10. |
Check the level of the following fluids and top up as required.
.
|
- |
Washer fluid
|
- |
Engine oil
|
- |
Coolant
|
- |
Brake fluid
|
- |
Power steering fluid
|
11. |
Remove the protection from the following
places in the cabin
:
|
- |
the seats
|
- |
the rear seat
|
- |
the gear lever/selector
|
- |
the steering wheel
|
- |
the floor
|
- |
the door trim on the driver's side
|
- |
the front sills
|
- |
the lower dashboard
|
- |
Cars with navigation system:
the navigation unit display.
|
12. |
Remove the VIN label from the side window in the rear door.
|
13. |
Remove the
separately packed parts
from the glove box.
|
- |
Fit the
cover
over the lock cylinder on the front left door.
|
- |
CV:
Fit the radio antenna rod.
|
- |
Cars with navigation system:
Load the map disc in the navigation unit's DVD player.
CV: The navigation disc is factory-inserted; check! |
- |
Fit
Wheel bolt caps
|
14. |
Set date and time
.
|
15. |
Check the function of the
wash/wipe system
.
|
16. |
Clear fault codes in all systems.
|
17. |
Perform
Configuration of dipped beam/front fog lights
.
|
18. |
Mount number plates.
|
19. |
Cars with pinch protection:
Remove fuse F5 from the instrument panel. Fit fuse F5. Carry out
Programming pinch protection
.
|
20. |
Test-drive
the car.
|
21. |
Make sure no fault codes have been detected in any of the systems.
|
22. |
Check that the cover over the data link connector is firmly in place.
|
23. |
Remove the towing eye, close the cover, remove the spare wheel and place the towing eye in the toolbox. Fit the spare wheel, if present.
|
24. |
Clean the car.
|