Solenoid, fuel filler flap, 5D (434 a)
Solenoid, fuel filler flap, 5D (434 a) |
To remove |
1. |
Open the boot lid.
|
2. |
Remove
C-pillar trim, 5D
.
|
3. |
Remove
Rear side trim, 5D
.
|
4. |
Fold away the insulation mat.
|
5. |
Undo the solenoid retaining bolts and lift up the solenoid. Pull off the rubber bellows from the tank filler neck.
|
6. |
Unplug the connector.
|
Fitting the solenoid with an old bellows |
1. |
Pull out the solenoid bellows slightly.
|
2. |
Insert a pair of pointed pliers through the filler cap neck from outside. Grip the front bellows on the solenoid and pull it out through the whole.
|
3. |
Place the solenoid in the mounting and screw it on. Plug in the connector.
|
4. |
Check the operation of the tank flap lock.
|
5. |
Fold back the insulation mat.
|
6. |
Fit
Rear side trim, 5D
.
|
7. |
Fit
C-pillar trim, 5D
.
|
Fitting the solenoid with a new bellows |
1. |
Pull in the bellows through the hole in the filler cap neck using a pair of pliers.
|
2. |
Place the solenoid in the mounting and screw it on. Plug in the connector.
|
3. |
Cut off the end of the bellows as marked.
|
4. |
Check the operation of the tank flap lock.
|
5. |
Fold back the insulation mat.
|
6. |
Fit
Rear side trim, 5D
.
|
7. |
Fit
C-pillar trim, 5D
.
|
8. |
Close the tailgate.
|