Front bumper harness

Replace

Remove the front bumper shell .

Remove the cellular block from the bumper shell.

Unplug the wiring harness connectors from all components.

Carefully remove the wiring harness without damaging cable ties, etc. that are to be refitted.

Important
Fasten the wiring harness correctly so that there is no risk of it chafing or rattling.

Lay out the new wiring harness the same as the old one and secure it in the same way.

Note
Spray all contact surfaces with “Contact 61” to avoid verdigris formation.

Plug in the connectors to the respective component. If in doubt, consult the wiring diagram/component list of the system in question.

Use the guide tabs to fit the cellular block.

Fit the front bumper shell .