Synchromesh assembly, removal and fitting
Synchromesh assembly, removal and fitting |
To remove |
Note | ||
The gearbox remains in place. |
1. |
Remove the reversing light switch (2).
|
2. |
Remove the bearing housing cover (3) - see
Bearing housing cover gasket, replacement F17
.
|
3. |
Remove the main shaft - see
Bearing housing, dismantling and assembling, F17
.
|
4. |
Dismantle the main shaft. See
Main shaft, dismantling and assembly, F17
.
|
Replace the pertinent synchromesh assembly if necessary.
Note | ||
The 5th gear synchromesh assembly is removed and fitted as described in service procedure Bearing housing, dismantling and assembling, F17 . |
To fit |
1. |
Assemble the main shaft. See
Main shaft, dismantling and assembly, F 17
.
|
2. |
Fit the main shaft - see
Bearing housing, dismantling and assembling, F17
.
|
3. |
Fit the bearing housing cover (2). See
Bearing housing cover gasket, replacement F17
.
|
4. |
Re-fit the reversing light switch (4) to the gearbox with a new sealing ring. Tightening torque 20 Nm.
|
5. |
Check the gearbox oil level. See
Gearbox oil level, checking and correcting F17
.
|