SAAB WIS ONLINE

Power steering pump, B284

Power steering pump, B284

To remove


1. Remove Drive belt, auxiliary .

2. Remove pipe, mass air flow sensor and hose from the turbo.


3. Remove the upper engine cover

4. Remove the turbo delivery pipe.


5. Raise the car.

6. Remove the turbo delivery pipe and the bolt securing the turbo delivery pipe to the AC compressor.


7. Lower the car to the floor.

8. Remove the turbo delivery pipe bolts on the front of the engine.

9. Remove the battery cover and radiator pipe.

10. Remove the upper radiator mounting from the radiator member.


11. Press forward the radiator and remove the turbo delivery pipe.

12. Clamp the supply hose with 30 07 739 Hose pinch-off pliers .


13. Remove the delivery hose from the power steering pump, use 32 025 061 Special wrench .

14. Remove the supply hose from the power steering pump.


15. Remove the power steering pump, press forward the radiator and lift out the pump.



To fit


1. Fit the power steering pump.

Tightening torque 22 Nm (16 lbf ft)


2. Fit the supply hose and remove the pliers.


3. Fit the delivery hose.

Tightening torque 30 Nm (22 lbf ft)


4. Press forward the radiator and fit the turbo delivery pipe. (Do not fasten yet.)

5. Raise the car.

6. Fit the turbo delivery pipe to the AC compressor and connect the hose.


7. Lower the car to the floor.

8. Tighten the delivery pipe screws.

9. Fit the upper turbo delivery pipe.

10. Fit the radiator mountings.


11. Fit the pipe, mass air flow sensor and hose to the turbo.


12. Fit the upper engine cover.

13. Fit Drive belt, auxiliary .

14. Fit the radiator pipe and battery cover .

15. Fill with oil as specified and bleed the power steering system . Check for any leaks.