SAAB WIS ONLINE

Front rubber bushes in rear axle, replacement, A20NFT

Front rubber bushes in rear axle, replacement, A20NFT

To remove


1. Raise the car.

2. Remove Complete exhaust system, A20NFT/LHU .

3. Remove propeller shaft .

4. Remove the hooks (A) from the control module and take the protective cover (B) off the hydraulic pump.


5. Undo the cable clips (A).


6. Dismantle the electrical connection (A).


7. Support the differential clutch and limited slip differential with a pillar jack, secure with a strap (A).


8. Remove screws (B) from the differential clutch and limited slip differential.

9. Lower the differential clutch and limited slip differential enough to remove the rubber bushings, be careful not to damage the drive joints.

10. Fit the tool (A) DT-49126-1 Press tool together with the hydraulic press tool.


11. Press out the rubber bush.

12. Remove the second rubber bush in accordance with step 10.


To fit


1. Fit the rubber bush in the housing with the bevels (A) as illustrated and press the bush into the housing with tool DT-49126-2 Press tool (B) and the hydraulic tool.


2. Fit the second rubber bush in accordance with step 1.

3. Raise the differential clutch and limited slip differential.

4. Fit screws (B) to the differential clutch and limited slip differential.

Tightening torque: 90 Nm (66.4 lbf ft) + 90°+15°


5. Remove the strap (A).

6. Fit the electrical connection (A).


7. Fit the cable clips (A).


8. Fit the protective cover (A) to the hydraulic pump and attach the hooks (B) to the control module.


9. Fit the propeller shaft .

10. Fit Complete exhaust system, A20NFT/LHU .

11. Lower the car to the floor.