DTC P0601-P0604, P0606, or P062F (Fuel Pump Control Module)
DTC P0601-P0604, P0606, or P062F (Fuel Pump Control Module) |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptors |
DTC P0601
Control Module Read Only Memory (ROM)
DTC P0602
Control Module Not Programmed
DTC P0603
Control Module Long Term Memory Reset
DTC P0604
Control Module Random Access Memory (RAM)
DTC P0606
Control Module Internal Performance
DTC P062F
Control Module Long Term Memory Performance
Circuit/System Description |
The internal fault detection is handled inside the fuel pump control module. No external circuits are involved.
Conditions for Running the DTC |
The fuel pump control module runs the program to detect an internal fault when power up is commanded. The only requirements are voltage and ground. This program runs even if the voltage is out of the valid operating range.
Conditions for Setting the DTC |
The fuel pump control module has detected an internal malfunction.
Action Taken When the DTC Sets |
DTC P0601, P0602, P0603, P0604, P0606 and P062F are type A DTCs.
Conditions for Clearing the DTC |
DTC P0601, P0602, P0603, P0604, P0606 and P062F are type A DTCs.
Reference Information |
Description and Operation
Fuel System Description (LF1) Fuel System Description (LAU or LY7)
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Circuit/System Verification |
Note | ||
This DTC may be stored as a history DTC without affecting the operation of the module. If stored only as a history DTC and not retrieved as a current DTC, do not replace the module. |
Verify that DTC P0602 is not set.
Verify that DTCs P0601, P0603, P0604, P0606, and P062F are not set.
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for fuel pump control module replacement, setup, and programming