DTC C056D
DTC C056D |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptor |
DTC C056D 00
Electronic Control Module, Hardware
DTC C056D 0F
Signal Disturbances in Electronic Control Module Components
DTC C056D 18
Electronic Control Module Components, Low Signal Amplitude
DTC C056D 31
Electronic Control Module Components, Internal Checksum Error
DTC C056D 32
Electronic Control Module Components, General Memory Error
DTC C056D 33
Electronic Control Module Components, Special Memory Error
DTC C056D 34
Electronic Control Module, Machine Performance, RAM Error
DTC C056D 35
Electronic Control Module, Hardware Performance, ROM Error
DTC C056D 36
Electronic Control Module, Machine Performance, EEPROM Error
DTC C056D 37
Electronic Control Module Components, Malfunction
DTC C056D 39
Internal Component Fault Detected
DTC C056D 3A
Electronic Control Module Components Incorrectly Installed
DTC C056D 3B
Electronic Control Module Components, Self-Test Malfunction
DTC C056D 3C
Electronic Control Module Components, Internal Malfunction
DTC C056D 43
Electronic Control Module Components, EEPROM Incorrectly Programmed
Circuit/System Description |
The internal fault detection is handled inside the control module. The symptom byte listed in the DTC Descriptor is for engineering reference only. No external circuit diagnosis is involved.
Conditions for Running the DTC |
The module runs the program to detect an internal fault when power up is commanded. The only requirements are voltage and ground. This program runs even if the voltage is out of the valid operating range.
Conditions for Setting the DTC |
The module has detected an internal malfunction.
Action Taken When the DTC Sets |
The module refuses all additional inputs.
Conditions for Clearing the DTC |
• |
A current DTC clears when the malfunction is no longer present.
|
• |
A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.
|
Diagnostic Aids |
• |
This DTC may be stored as a history DTC without affecting the operation of the module.
|
• |
If stored only as a history DTC and not retrieved as a current DTC, do not replace the module.
|
• |
If this DTC is retrieved as both a current and history DTC, replace the module that set the DTC.
|
Circuit/System Verification |
1. |
Verify that DTC C056D is not set.
|
2. |
If the DTC is set in a control module that can be programmed, program the control module. If the DTC resets, replace the control module that set the DTC.
|
3. |
If the DTC is set in a control module that can not be programmed, replace the control module that set the DTC.
|
4. |
If the DTC is set in a sensor, replace the sensor that set the DTC.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for module replacement, programming and setup