Front Object Alarm Sensor Housing Replacement

/ 9-4x / 2011 / 3. Electrical System / Traffic safety system / Adjustment/replacement / Front Object Alarm Sensor Housing Replacement

1.	Remove the front fascia. Refer to Front Bumper Fascia Replacement .

2.	Disconnect the sensor harness.

3.	Remove the sensor from the sensor housing. The sensor housing must be painted if replaced. If reinstalled, painting will not be necessary.

4.	Note Do Not grind off alignment tabs. Sand/grind sonic weld plastic residue from the fascia.

5.	Apply structural adhesive epoxy, Lord Fusor™ 127EZ or equivalent, to fascia at mating surface.

6.	Using the alignment tabs, install the sensor housing to the fascia.

7.	Allow adhesive to cure according to manufacturer's directions.

8.	Install the sensor to the sensor housing.

9.	Connect the electrical harness.

10.	Install the front fascia. Refer to Front Bumper Fascia Replacement .

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.