SAAB WIS ONLINE

Differential Carrier Bushing Replacement - Front

Differential Carrier Bushing Replacement - Front



Callout Component Name

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

2. Remove the propeller shaft. Refer to Propeller Shaft Replacement .

3. Remove the exhaust system. Refer to Exhaust Muffler Replacement (LAU) Exhaust Muffler Replacement (LF1) .


1 Differential Carrier Bushing - Front (Qty: 2)

Procedure

1. Support the rear differential with a hydraulic transmission jack stand.

2. Remove the electrical connector from the rear differential clutch control module. Refer to Rear Differential Clutch Control Module Replacement .

3. Remove the front and rear differential mounting bolts. Refer to Differential Carrier Assembly Replacement .

4. Lower the rear differential until there is enough room to remove the differential carrier bushings

5. Using the DT 49126-1 tool and the DT 49126-10 kit , remove the rear differential bushing.

6. Position the NEW rear differential bushing with the beveled edges facing the housing (up).

7. Using the DT 49126-2 tool and the DT 49126-10 kit , install the NEW rear differential bushing.



Special Tools

DT 49126-1 Press Tool

DT 49126-2 Press Tool

DT 49126-10 Bushing Replacer Hardware Kit


For equivalent regional tools, refer to Special Tools .