SAAB WIS ONLINE

Inflatable Restraint Front Passenger Presence Sensor Replacement

Inflatable Restraint Front Passenger Presence Sensor Replacement



Callout Component Name
Warning

Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.


Warning

To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction.



Preliminary Procedures

1. Remove the passenger front seat. Refer to Driver or Passenger Seat Replacement .

2. Remove the front seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement .


1 Inflatable Restraint Front Passenger Presence System Assembly

Procedure

1. Preload Test the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed.

Refer to Control Module References .

2. Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References .

3. Disengage the inflatable restraint sensor bracket with the sensor from the seat cushion spring.

4. Disengage the sensor from the bracket.

5. Disengage the passenger presence system assembly from the seat cushion by sliding the sensor belt through the cushion pad.


Note
The passenger presence system is an integral part of the pad on the passenger seat cushion.

The sensor, module and seat cushion pad must be replaced as a unit.

Note the routing of the wiring harness and connector location for installation.