Liftgate Adjustment

/ 9-4x / 2011 / 8. Body / Doors and locks / Adjustment/replacement / Liftgate Adjustment

1.	Note the original position of the liftgate latch striker.

2.	Loosen the striker. Refer to Liftgate Latch Striker Replacement .

3.	Loosen the hinge-to-roof panel bolts for forward or rearward adjustments.

4.	If adjusting the hinge-to-roof panel bolts, lower the rear headliner as needed. Refer to Headlining Trim Panel Replacement (With C3U) Headlining Trim Panel Replacement (Without C3U) .

5.	Loosen the liftgate-to-hinge bolts for up and down adjustment.

6.	Move the liftgate within the liftgate opening to achieve the best alignment and operation.

7.	Position the striker to approximately the proper position.

8.	Adjust the striker to achieve the best operation and alignment of the liftgate.

9.	Inspect the seals for proper engagement.

10.	Refer to Fastener Caution . Tighten the hinge-to-roof bolts when the proper adjustment is achieved to 25 Nm (18 lb ft) .

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.