SAAB WIS ONLINE

Drive shaft seal, left-hand

Drive shaft seal, left-hand

Replacement in car

To remove


1. Raise the car and remove the wheel.

2. Remove the drive shaft from the gearbox using 87 92 616 Removal tool, drive shafts .

3. Remove the clips for the brake hose and the mountings for the ABS lead


4. Remove the bolt securing the ball joint to the steering swivel member. Pry loose and lower the suspension arm. Fixate it in position with a wooden block placed between the suspension arm and anti-roll bar.

5. Swing the wheel to the right to facilitate removing the drive shaft. Grab hold of the MacPherson strut and pull. The drive shaft will follow. Then lower it in front of the suspension arm.

Important

Position a container under the gearbox to avoid oil spills on the floor.


6. Remove the seal using 87 92 350 Puller, drive shaft seal and 87 91 683 Puller ,



To fit



1. Tap in the new seal with 83 90 122 Drift . Lubricate the seal with gearbox oil, see

2. Insert 83 95 162 Protective sleeve, drive shafts into the sealing ring.

3. Make sure that the drive shaft is clean and then fit the drive shaft in the tool.

Important

Fit the drive shaft in the gearbox until approx. 20 mm remain and pull out the tool before the shaft sealing surface reaches the shaft seal.


4. Push in the rest of the shaft until the circlip clicks in.


5. Fit the ball joint to the steering swivel member and tighten.

Tightening torque 100 +45° (74 lbf ft)

Warning

Make sure that the steering spindle journal is visible above the steering swivel member before the bolt is fitted.


6. Fit the brake line in the mounting on the steering swivel member and fit the clip as well as the two mountings for the ABS lead.

7. Fit the wheel and tighten the wheel bolts.

Tightening torque 110 Nm (80 lbf ft)

Important

The wheel must hang freely when the wheel bolts are being tightened.


8. Fill oil in the gearbox to the correct level.


Replacement of O-ring in car


To remove


1. Remove the wheel.

2. For removing the drive shaft see 4. Power transmission, Drive shafts, Adjustment and replacement "Removing" steps 4-7.

3. Remove the seal retainer.

4. Change O-ring.


To fit



1. Fit the seal retainer.

2. For who to fit the drive shaft, refer to Drive shaft , "To fit", steps 2-11.