SAAB WIS ONLINE

Boot lid 4D

Boot lid 4D

To remove



1. Open the boot lid.

2. Open the hatch in the trim in front of the left-hand rear lamp and unplug the connector to the boot lid wiring harness.

3. Remove the grommet hose from the body and unfasten it from the hinge.

4. Remove the clip securing the gas spring to the ball joint.


5. Remove the gas spring from the hinge.

6. Remove the two lower nuts holding the lid to the hinge

7. Unscrew the two top nuts a few turns.

8. Carefully lift off the boot lid.


To fit



1. Put the boot lid on its hinges.

2. Screw on the nuts.

3. Fit the gas springs to the hinges and fit the clips.

4. Insert the wiring harness through the grommet hose and attach the hose to the hinge.


5. Plug in the connector.

6. Check the fit of the lid and adjust if necessary, see .