Boot lid 4D, adjustment
| Boot lid 4D, adjustment |
| Adjusting the height of the entire boot lid |
When adjusting or changing the boot lid on cars with VIN 3039285 - 3043680, the gap between the bolt head and the water channel must be sealed according to Boot lid hinges, 4D .
Adjust the height of the boot lid by loosening the screws holding the hinges to the body and moving the hinges up or down.
| Adjusting the front of the boot lid |
| 1. |
Loosen the front two screws on the hinges.
|
|
| 2. |
Loosen the rear retaining screw just enough to allow the front of the hinge to be adjusted upwards or downwards.
|
|
| 3. |
Then tighten the front screw and check fit and function.
|
|
| 4. |
Tighten the remaining screws.
|
|
| Adjusting the rear of the boot lid |
The position of the rear of the boot lid when it is closed is determined by the two rubber buffers mounted on it.
| 1. |
Adjust the buffers by screwing them in or out.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
