SAAB WIS ONLINE

Receiver

Receiver

To remove



1. Place the car on a lift.

2. Drain the refrigerant from the A/C system, see .

3. Remove the grille and left headlamp as well as direction indicator.

4. Remove the front covering below the radiator unit.


5. Detach the A/C pipe connections from the receiver.


Plug the openings.

6. Loosen the receiver and holder from the left-hand side of the condenser.

Plug the condenser.

7. Lower the receiver under the car.



To fit



1. Adjust the oil volume in the compressor, see .

Lift up the receiver and holder to the condenser.

2. Adjust the position of the receiver so that the PAD connections are parallel.

3. Lubricate the O-ring and fit the receiver.

4. Remove the plugs and lubricate the O-rings on the receiver pipes.

5. Screw on the A/C pipe connections to the receiver.

Tightening torque: 8 Nm (5.9 lbf ft)

6. Fit the front covering below the radiator unit.


7. Vacuum pump the A/C system and fill with R134a refrigerant, see .


8. Fit the left headlamp, direction indicator and grille.