Selector lever housing
Selector lever housing |
To remove |
1. |
Remove the centre and floor consoles, see
Centre console
Remove the air duct to the rear air vent. |
2. |
Remove the circlip and the anti-rattle clip.
|
3. |
Drive out the pin while removing the end of the cable from the ball.
|
4. |
Remove the screws securing the selector lever housing.
|
5. |
Unplug the selector lever housing's connector.
|
6. |
Lift up the selector lever housing, undo the cable ties securing the wiring harness to the ignition switch and airbag, and unplug the electrical connection to the ignition switch.
|
7. |
Remove the clamp located beside the locking catches.
|
8. |
Carefully press the catches securing the cable ferrule towards each other and remove the cable from the bracket.
|
9. |
Lift out the selector lever housing.
|
Fitting |
1. |
Fit the selector lever housing in place.
|
2. |
Connect the cable to the selector lever housing and fit the clamp.
|
3. |
Plug in the electrical connection to the ignition switch while putting the selector lever housing in place.
|
4. |
Refit the 2 cable ties for the wiring harness.
|
5. |
Push in the pin at the same time as the ball enters the end of the cable. Grip the end of the cable.
|
6. |
Fit the circlip and the anti-rattle clip.
|
7. |
Connect the air duct and tighten the selector lever housing.
|
8. |
Fit the centre and floor console, see group 8 Body, climate system, Interior equipment.
|
9. |
Adjust the position of the cable.
|