SAAB WIS ONLINE

P1653

Read the instructions below then start the fault diagnostic procedure.

Symptom: CHECK ENGINE lamp on. Before starting fault diagnosis, see Engine stalls or engine does not start

P1653


Main Relay Circuit. No Voltage to Control Module.


Fault symptoms


• CHECK ENGINE lamp on.

Note

Before starting fault diagnosis, see Engine stalls or engine does not start



Conditions

The following conditions apply for this DTC:


• The main relay has closed too early. If the voltage on pin 28 disappears after three attempts to start the engine, the DTC is generated.

The main relay has been closed too late. The delay function includes a check of the main relay circuit. A timer is started when the control module ceases to ground pin K28 to the main relay. If it takes longer than 3 seconds for the current to disappear from pin 5 after grounding of K28 has ceased, 3 times in succession, the diagnostic trouble code will be generated the next time the ignition is turned on.


Diagnostic help

A loose contact or poor ground connection can cause the control module to experience a break in the current. When a fault occurs that generates P1653, then DTCs can also be generated for the components that are supplied with power from the main relay.