SAAB WIS ONLINE

Rear crankshaft seal

Rear crankshaft seal

To remove



1. Remove the gearbox, see To remove .

2. Remove the pressure plate and clutch plate, see Changing clutch assembly .

3. Remove the flywheel.

4. Screw in a self-tapping screw and pull out the seal.


To fit



1. Clean any gasket remains from the sealing surfaces.

2. Lubricate the new seal with non-acidic Vaseline and position it on 83 95 402 Assembly tool, rear crankshaft seal (KM-934-1).

3. Position the seal on the crankshaft with 83 95 402 Assembly tool, rear crankshaft seal . Press in the seal with the tool until it is flush with the cylinder block.

4. Fit the flywheel with new bolts. Use 83 94 868 Flywheel locking attachment for support.

Tightening torque: 45 Nm (33 lbf ft) + 30°.

5. Fit the pressure plate and clutch plate, see Changing clutch assembly .

6. Fit the gearbox, see To fit .