Ignition switch
Ignition switch |
2. |
Remove the gear selector casing, see
.
|
3. |
Snip the cable tie holding the lead for the lighting button in place.
|
4. |
Snip the cable tie securing the lead for the electromagnet.
|
5. |
Remove the electromagnet pins 5 and 6 from the connector.
|
6. |
Remove the shift indication display. Remove the screws securing the ignition switch.
|
7. |
Drill out the rivets.
|
8. |
Dismantle the selector lever housing.
|
9. |
Remove the selector lever retaining bolt.
|
10. |
Remove the selector lever with holder from the base plate.
|
11. |
Remove the lock washer and tap out the spacer sleeve.
|
12. |
Detach the selector lever from the holder.
|
13. |
Remove the retention pin holding the wire sheath.
|
14. |
Remove the clip from the lock pin.
|
15. |
Pull the wire out of the holder.
|
To fit |
1. |
Connect the wire to the holder and lock pin.
|
2. |
Fit the retention pin holding the wire sheath.
|
3. |
Fit the clip to the lock pin.
|
4. |
Fit the selector in the holder.
|
5. |
Insert the spacer sleeve through the selector lever, ignition switch retaining catch, shift-lock retaining catch and holder. Fit the lock washer.
|
6. |
Fit the selector lever with holder into the groove at the front of the base plate.
|
7. |
Fit the bolt and tighten it.
|
8. |
Fit the selector lever and ignition switch in the selector lever housing. Place the sport button's lead in the clip.
|
9. |
Rivet together the selector lever housing.
|
10. |
Screw on the ignition switch. Fit the gear indicator display.
|
11. |
Fit a cable tie to hold the lead for the lighting in place.
|
12. |
Plug in the electromagnet's connector.
|
13. |
Fit a cable tie through the hole in the gear selector and around the electromagnet cable.
|
14. |
Fit the ignition switch cylinder, see
.
|
15. |
Fit the gear selector casing, see
.
|
16. |
Fit the selector lever housing, see
.
|