Energy absorber for improved head protection in case of impact.
|
|
Energy absorber for improved head protection in case of impact.
|
When changing interior fittings, it should be especially noted that the car is equipped with absorbents to protect the head of the passenger or driver in the event of an impact. These absorbents are mounted between the trim and bodywork and have different shapes according to where they are located. It is important to ensure that both absorbent and trim are intact and correctly fitted in the car to afford the right degree of protection.
See also
A pillar trim
,
B pillar trim
,
C pillar trim, 4D
,
C pillar trim, 5D
,
Headlining, 4D
and
Headlining, 5D
for instructions when changing components.
|
Diagnostic procedure when repairing after a collision
|
The following rules are applicable when repairing a car that has been involved in a collision and where at least one airbag has been triggered.
|
•
|
If the car was carrying passengers in the rear seat, all absorbents must be changed.
|
|
•
|
If passengers were present only in the front seat, the front absorbents as far as the B pillar must be changed.
|
|
•
|
If the roof or pillars were damaged they must be changed.
|
|
•
|
In cases of uncertainty, all absorbents should be changed.
|
|
•
|
If the trim or absorbent show visible damage they must be changed.
|
The following rules must be followed when repairing interior fittings where energy absorbents are mounted.
|
•
|
Work on roof pillars and the headlining should be carried out only by an authorized service workshop.
|
|
•
|
All work must be performed in accordance with given instructions and all due care should be taken.
|
|
•
|
System components must not be dismantled or repaired. They should be handled with care.
|
|
•
|
A defective component must not be fitted.
|
