P1925
Read the instructions below then start the fault diagnostic procedure.
Symptom:
| P1925 |
TCS/ESP Missing on BUS
On-Board Diagnostics
Type of diagnosis:| - |
Continuous
|
|
Enable criteria:
| - |
Turn Ignition On.
|
|
Fault criteria:
| - |
Missing or faulty signal communication with the TCS/ESP.
|
|
OK report:
| - |
Fault criteria not fulfilled.
|
|
Check the wiring
A fault in the control module's female connector can generate a DTC. Check the contact for oxidation, dislodge pins and pin clamping force.Jiggle the leads and in-line connectors at various points and in different directions to detect any intermittent breaks or short circuits in the wiring. Observe the multimeter, test lamp or diagnostic tool while doing this. Check switches, connectors and crimp connections for oxidation, dislodged pins and pin clamping force.
For more information, see also:
- "Read Values" menu for a description of read values.
- "Activate" menu for a description of applications.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
