Control module
Control module |
To remove |
Biopower: Before and after control module replacement, carry out Procedure upon control module replacement and during SPS of Trionic T7 Biopower E85
1. |
Remove the blanking-off washers on the wiper spindle nuts and loosen the nuts slightly.
|
2. |
Loosen the wiper arms with a puller, special tool (part no. 85 80 144). Remove the nuts and wiper arms.
|
3. |
Remove the rubber wiper spindle seals.
|
4. |
Remove the two screw clips on the ends of the windscreen cover.
|
5. |
Loosen the rubber seal.
|
6. |
Remove the windscreen cover by grasping the front edge and lifting upward/forward. Be careful with the bonnet release wire on the left-hand side.
|
7. |
Undo the protective cover on the control module.
|
8. |
Tilt up the cover and unplug the control module multiconnector by releasing the catch on the right.
|
9. |
Undo the control module's 2 retaining nuts and remove them. A 10 mm magnetic socket will be useful for this.
|
10. |
Lift the control module straight up.
|
Important | ||
ESD-SENSITIVE COMPONENT |
||
Earth yourself by touching the car body before plugging in / unplugging components. Do not touch the component pins. Read Before changing a control module before changing a control module. |
||
To fit |
1. |
Position the control module from above.
|
2. |
Fit the 2 control module retaining nuts.
|
3. |
Spray the control module multiconnector with Kontakt 61 (part no. 30 04 520) and plug in the connector.
|
4. |
Fit the protective cover on the control module.
|
5. |
Fit the windscreen cover. Be careful with the bonnet release wire on the left-hand side.
|
6. |
Fit the rubber seal.
|
7. |
Fasten the screw clips on the ends of the windscreen cover.
|
8. |
Fit the rubber wiper spindle seals.
|
9. |
Fit the nuts on the wiper spindles with the blanking-off washers on the nuts.
|
10. |
Perform
Measures after changing a control module
.
|
11. |
Reset immobilization as follows:
|
• |
Connect Tech2 and turn the ignition to ON
|
• |
Select Body and TWICE
|
• |
Select Immobilization. After 10 seconds the immobilizer is programmed.
|