SAAB WIS ONLINE

DTC P0611 (LBY)

DTC P0611 (LBY)

Diagnostic Instructions


Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

Review Strategy Based Diagnosis for an overview of the diagnostic approach.

Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptors

DTC P0611 91

Control Module Performance

DTC P0611 92

Control Module Performance

DTC P0611 93

Control Module Performance

DTC P0611 94

Control Module Performance

DTC P0611 A2

Control Module Performance

DTC P0611 A3

Control Module Performance

DTC P0611 A4

Control Module Performance

DTC P0611 A5

Control Module Performance

DTC P0611 A6

Control Module Performance

DTC P0611 A7

Control Module Performance

DTC P0611 A8

Control Module Performance

DTC P0611 A9

Control Module Performance

DTC P0611 AA

Control Module Performance

Circuit/System Description

These DTCs apply to internal microprocessor integrity conditions within the engine control module (ECM). This diagnostic also addresses if the ECM is not programmed.

Conditions for Running the DTC


The ignition is ON.

The DTCs run continuously once the above condition is met


Conditions for Setting the DTC

The ECM detects an internal condition for greater than 1 second.

Action Taken When the DTC Sets

DTC P0611 is a Type A DTC.

Conditions for Clearing the DTC

DTC P0611 is a Type A DTC.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Testing


1. Observe the Freeze Frame/Failure Records with a scan tool.

2. Clear the DTCs with a scan tool.

3. Ignition OFF for 30 s.

4. Run the vehicle within the Conditions for Running the DTCs. You may also operate the vehicle within the conditions that you have noted from the Freeze Frame/Failure Records.

5. If DTC P0611 failed this ignition, replace the K20 Engine Control Module.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for ECM replacement, setup, and programming