DTC P0658 or P0659
DTC P0658 or P0659 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptors |
DTC P0658 00
Actuator High Control Circuit Group 1 Low Voltage
DTC P0659 00
Actuator High Control Circuit Group 1 High Voltage
Circuit/System Description |
These DTC apply to internal 5 V reference voltage supply within the engine control module (ECM).
Conditions for Running the DTC |
• |
The ignition is ON.
|
• |
The DTCs run continuously once the above condition is met
|
Conditions for Setting the DTC |
P0658
The internal 5 V reference voltage is too low.P0658
The internal 5 V reference voltage is too high.Action Taken When the DTC Sets |
DTC P0658 and P0659 are Type C DTCs.
Conditions for Clearing the DTC |
DTC P0658 and P0659 are Type C DTCs.
Reference Information |
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Circuit/System Testing |
1. |
Observe the Freeze Frame/Failure Records with a scan tool.
|
2. |
Clear the DTCs with a scan tool.
|
3. |
Ignition OFF for 30 s.
|
4. |
Run the vehicle within the Conditions for Running the DTCs. You may also operate the vehicle within the conditions that you have noted from the Freeze Frame/Failure Records.
|
5. |
If DTC P0658 or P0659 is reset this ignition, replace the K20 Engine Control Module.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ECM replacement, setup, and programming