DTC P160E
DTC P160E |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptor |
DTC P160E 00
Engine Calibration Monitoring Not Programmed
Circuit/System Description |
This diagnostic addresses if the ECM is not programmed with the engine calibration.
Conditions for Running the DTC |
• |
The ignition is ON.
|
• |
The DTC runs continuously once the above condition is met.
|
Conditions for Setting the DTC |
The ECM detects that the engine calibration is not programmed in the EEPROM for greater than 1 second.
Action Taken When the DTC Sets |
DTC P160E is a Type A DTC.
Conditions for Clearing the DTC |
DTC P160E is a Type A DTC.
Reference Information |
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type DefinitionsCircuit/System Testing |
Program the ECM. If DTC P160E sets after programming, perform the following steps:
• |
Ensure that all tool connections are secure.
|
• |
Ensure the programming equipment is operating correctly.
|
• |
Ensure the correct software and the correct calibration is used.
|
• |
Attempt to program the K20 Engine Control Module.
|
• |
If DTC P160E sets, replace the K20 Engine Control Module.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References