SAAB WIS ONLINE

DTC P2458

DTC P2458

Diagnostic Instructions


Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

Review Strategy Based Diagnosis for an overview of the diagnostic approach.

Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptor

DTC P2458 51

Diesel Particulate Filter (DPF) Regeneration Time

DTC P2458 56

Diesel Particulate Filter (DPF) Regeneration Time

DTC P2458 57

Diesel Particulate Filter (DPF) Regeneration Time

Circuit/System Description

The soot particles accumulate in the channels of the DPF and are burned off at regular intervals, through a process called regeneration or cleaning. The DPF cleaning process prevents the DPF from clogging. Excess soot in filter can cause a drop in engine performance and crack the filter during regeneration.

Conditions for Running the DTC


The engine is running.

The engine coolant temperature (ECT) is between 73-96°C (163-205°F).


Conditions for Setting the DTC


The ECM detect to long regeneration times

The above condition is met.


Action Taken When the DTC Sets

DTC P2458 is a Type C DTC.

Conditions for Clearing the DTC

DTC P2458 is a Type C DTC.

Reference Information

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference


Circuit Testing

Connector Repairs

Testing for Intermittent Conditions and Poor Connections

Wiring Repairs


DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References

Circuit/System Verification


1. The following conditions must be met for the ECM to perform the turbocharger learn procedure:

The A/C is OFF.

The vehicle is in Park or Neutral.

Start and run the engine.

The engine coolant temperature (ECT) is greater than 40°C (104°F).

2. Perform the DPF Service Regeneration.

3. Verify the DTC does not reset.

4. If the DTC resets, replace the DPF filter.