Transmission Control Module Programming and Setup
|
Transmission Control Module Programming and Setup
|
The following service procedures require either a programming or a setup event performed for a complete repair.
Transmission Control Module Replacement
|
If the transmission control module (TCM) needs to be replaced, the following procedures must be performed:
2.
|
Perform the SPS function Transmission Control Module - Programming and follow the on-screen instructions.
|
3.
|
Perform the SPS function Transmission Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both control module Configuration/Reconfiguration and the appropriate control module Setup.
|
4.
|
Clear DTCs after completing the programming procedure.
|
Transmission Control Module Reprogramming
|
Do not reprogram the transmission control module (TCM) unless directed by a service procedure or a service bulletin.
2.
|
Perform the SPS function Transmission Control Module - Programming and follow the on-screen instructions.
|
3.
|
Clear DTCs after completing the programming procedure.
|
Setup for Component Replacement
|
The replacement of following components will require to reset learned values and N position calibration, refer to
Transmission Adaptive Functions
.
The replacement of following components will require N position calibration, refer to
Transmission Adaptive Functions
.
•
|
Transmission control replacement
|