SAAB WIS ONLINE

Rear Wheel Bearing and Hub Replacement (GNE, AWD)

Rear Wheel Bearing and Hub Replacement (GNE, AWD)



Callout Component Name

Preliminary Procedure

1. Remove the rear tire and wheel. Refer to Tire and Wheel Removal and Installation .

2. Remove and support the brake caliper and bracket as an assembly without disconnect the hydraulic brake hose from the caliper. Then remove the rear brake disc. Refer to Rear Brake Disc Replacement (J61, J62) or Rear Brake Discs Replacement (J60)

3. 3. Remove the rear axle upper control arm to knuckle bolt. Refer to Rear Axle Upper Control Arm Replacement (GNE) or Rear Axle Upper Control Arm Replacement (GNC)


1

Rear Wheel Hub Fastener (Qty: 3)

Caution: Refer to Fastener Caution in the introductory section.

Procedures

Install NEW bolts

Tighten

90 N·m (66 lb ft) + 75 degrees

3

Rear Wheel Bearing and Hub