SAAB WIS ONLINE

Inflatable Restraint Front Passenger Presence Sensor Replacement

Inflatable Restraint Front Passenger Presence Sensor Replacement



Callout Component Name
Refer to SIR Warning .

Warning

Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.


Warning

To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction.



Preliminary Procedure

1. Disable the SIR system. Refer to SIR Disabling and Enabling

2. Remove the driver or passenger seat. Refer to. Driver or Passenger Seat Replacement (2/4/6-Way Hybrid, 6-Way Hybrid Sport) Driver or Passenger Seat Replacement (8-Way-Power)

3. Remove the front seat cushion cover and pad. Refer to Driver or Passenger Seat Cushion Pad Replacement (8-Way-Power) Driver or Passenger Seat Cushion Pad Replacement (2/4-Way) Driver or Passenger Seat Cushion Pad Replacement (6-Way Hybrid, 6-Way Hybrid Sport) .


1

Inflatable Restraint Front Passenger Presence Sensor


Procedures

1. Disconnect the electrical connectors.

2. Preload Test the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Control Module References

3. Program the inflatable restraint passenger presence system after replacement. Refer to Inflatable Restraint Sensing and Diagnostic Module Programming and Setup .


Note
• The passenger presence system is an integral part of the pad on the passenger seat cushion.

• Note the routing of the wiring harness and connector location for installation.