Piston, Connecting Rod, and Bearing Installation
|
Piston, Connecting Rod, and Bearing Installation
|
Special Tools
EN-45059
Torque Angle Sensor Kit
For equivalent regional tools, refer to
Special Tools
.
1.
|
Lubricate the piston rings, piston, inner cylinder bore surface and a piston ring compressor with clean engine oil.
|
2.
|
Install the piston ring compressor in order to compress the piston rings.
|
3.
|
Install the piston and connecting rod assembly (4).
|
4.
|
Install the connecting rod bearing (3).
|
5.
|
Install the connecting rod cap (1).
|
6.
|
Refer to
Fastener Caution
.
Install the connecting rod bolts (2) and tighten to
35 Nm (26 lb ft) + 45 degrees
use the
EN-45059
sensor kit.
|
7.
|
Assemble the caps and connecting rods in the marked position.
|
8.
|
Rotate the crankshaft to a position where the connecting rod bolts are in the best situation for install.
|