Cylinder Head Installation - Right Side
Cylinder Head Installation - Right Side |
Special Tools
EN 49411 Torque Angle Sensor KitFor equivalent regional tools, refer to Special Tools .
1. |
Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.
Install a NEW cylinder head gasket bank 1 using the deck face locating pins for retention. |
2. |
Align the cylinder head bank 1 with the deck face locating pins.
|
3. |
Place the cylinder head bank 1 in position on the deck face.
|
4. |
Install NEW 8 cylinder head bolts. |
5. |
Refer to
Fastener Caution
.
Tighten the NEW 8 cylinder head bolts: |
5.1. |
First pass in sequence to
45 Nm(33 lb ft)
.
|
5.2. |
Tighten the second pass in sequence to an additional
120 degrees
using the
EN 49411
angle sensor.
|