Engine Front Cover Installation (LAU or LBW)

/ 9-5 (9650) / 2011 / 2. Engine / Basic engine, V6 / Adjustment/replacement / Engine Front Cover Installation (LAU or LBW)

Special Tools

EN-46109 Guide Pin Set

For equivalent regional tools, refer to Special Tools .

Install the 8 mm (0.315 in) guide from the EN-46109 pins into the cylinder block positions as shown.

Install the NEW engine front cover to cylinder block seal.

Place a 3 mm (0.118 in) bead of RTV sealant on the engine front cover as shown (1). Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended sealant.

Place the engine front cover onto the EN-46109 pins and slide into position.

Remove the EN-46109 pins from the cylinder block.

Install the engine front cover deadener.

Refer to Fastener Caution .

Note
The front cover and deadener may vary in appearance depending on application but are retained by the same number of bolts.

Loosely install the engine front cover bolts to hold the engine front cover deadener into position.

Loosely install the remaining engine front cover bolts.

Note
Engine front cover bolts in the number (23) location are model dependent and may not apply.

Tighten the engine front cover bolts (1-22) in sequence shown to 20 Nm (14 lb ft) .

10.

Tighten the engine front cover bolts (1-22) a second pass in sequence an additional 60 degrees .

11.

Tighten the front engine cover bolts (23) in the sequence shown to 65 Nm (48 lb ft) .

12.

Place the camshaft position actuator valves in position on the front cover.

13.

Install the camshaft position setting-valve bolts and tighten to 10 Nm (89 lb in) .

14.

Install NEW O-rings on the camshaft position sensor.

15.

Place the camshaft position sensors in position on the front cover.

16.

Install the camshaft position sensor screws and tighten to 10 Nm (89 lb in) .