SAAB WIS ONLINE

Engine Prelubing

Engine Prelubing



Special Tools

• EN 21867-6 Oil Pressure Adapter Fitting

• EN 45299 Engine Preluber


For equivalent regional tools, refer to Special Tools


1.
Note

A constant and continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.


Remove the oil filter cap.


2. Install the NEW oil filter cartridge.

3. Lubricate the threads of the oil filter cap with clean engine oil.

4. Refer to Fastener Caution .

Install the oil filter cap and tighten to 25 Nm (18 lb ft) .

5. Remove the oil pressure sending unit from the oil filter adapter.

6. Install the EN 21867-6 fitting.

7. Install the flexible hose to the adapter and open the valve.


8. Pump the handle on the EN 45299 preluber in order to flow a minimum of 1-1.9 liters (1-2 quarts) of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.

9. Close the valve and remove the flexible hose and adapter from the engine.

10. Install the oil pressure sending unit and tighten to 20 Nm (15 lb ft) .

11. Top-off the engine oil to the proper level.