SAAB WIS ONLINE

Throttle Body Assembly Replacement

Throttle Body Assembly Replacement



Callout Component Name

Preliminary Procedure

1. Remove the engine cover. Refer to Engine Cover Replacement .

2. Remove the charge air cooler outlet pipe. Refer to Charge Air Cooler Inlet Pipe and Outlet Pipe Replacement (LBY/A20DTR) Charge Air Cooler Inlet Pipe and Outlet Pipe Replacement (LBS/A20DTH) .

3. Disconnect the electrical connector.


1

Throttle Body Fastener (Qty: 3)

Refer to Fastener Caution .

Tighten

10 Nm (7 lb ft)

2

Throttle Body Assembly

Warning

Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

Use care in cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as sharp tools may damage the gasket surfaces.


Warning

Do not use any solvent that contains Methyl Ethyl Ketone (MEK). This solvent may damage fuel system components.