SAAB WIS ONLINE

DTC B0987

DTC B0987

Diagnostic Instructions


• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptor

DTC B0987 05

Vehicle Direction Camera Indicator Circuit High Voltage/Open

Diagnostic Fault Information

Circuit Short to Ground Open/High Resistance Short to Voltage Signal Performance
Lane Departure Warning Switch Indicator Ignition

B0987 05

B0987 05

-

-

Lane Departure Warning Switch Indicator Control

-

B0987 05

B0987 05

-

Lane Departure Warning Switch Ground

-

B356A 05

-

-



Circuit/System Description

The lane departure warning is enabled and disabled through a switch located in the multifunction switch at the center console. When enabled, the vehicle direction camera control module will illuminate the indicator located in the switch.

Conditions for Running the DTC

Ignition ON

Conditions for Setting the DTC

The vehicle direction camera control module has detected a short to battery or open.

Action Taken When the DTC Sets


• Lane departure warning is disabled.

• SERVICE LANE DEPARTURE SYSTEM is displayed on the driver information center.


Conditions for Clearing the DTC

The condition for setting the DTC is no longer present.

Reference Information

Schematic Reference

Object Detection Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Object Detection Description and Operation (Traffic Sign Assist) Object Detection Description and Operation (Parking Assist with Parallel Parking) Object Detection Description and Operation (Parking Assist) Object Detection Description and Operation (Lane Departure Warning) Object Detection Description and Operation (UFT) Object Detection Description and Operation (UVC)

Electrical Information Reference


• Circuit Testing

• Connector Repairs

• Testing for Intermittent Conditions and Poor Connections

• Wiring Repairs


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification


1. Verify DTC B356A is not set.

2. If DTC is set, refer to DTC B356A .

3. Verify DTC B0987 is not set.

4. If DTC is set, refer to Circuit/System Testing.


Circuit/System Testing


1. Ignition OFF, disconnect the harness connector at the K74 Vehicle Direction Camera Control Module and the harness connector at the S48E Multifunction Switch - Center Console.

2. Ignition ON, test for greater than 11 V between the ignition circuit terminal 3 at the S48E Multifunction Switch - Center Console harness connector and ground.

3. If less than the specified value, test the ignition circuit for a short to ground or an open/high resistance.

4. Test for less than 0.3 V between the control circuit terminal 8 at the S48E Multifunction Switch - Center Console harness connector and ground.

5. If greater than the specified value, test the control circuit for a short to voltage.

6. Ignition OFF, test for infinite resistance between the control circuit terminal 8 at the S48E Multifunction Switch - Center Console harness connector and ground.

7. If less than the specified value, test control circuit for a short to ground.

8. Test for less than 5 Ω between the S48E Multifunction Switch - Center Console control circuit terminal 8 and the control circuit terminal 4 at the K74 Vehicle Direction Camera Control Module harness connector.

9. If greater than the specified value, test the control circuit for an open/high resistance.

10. If all circuits test normal, connect the harness connector to the K74 Vehicle Direction Camera Control Module, replace the S48E Multifunction Switch - Center Console and verify the DTC does not reset.

11. If the DTC resets, replace the K74 Vehicle Direction Camera Control Module.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.


• Front Floor Console Multifunction Switch Replacement

• Control Module References for vehicle direction camera control module replacement, setup and programming