SAAB WIS ONLINE

Rear Axle Replacement (Without G96)

Rear Axle Replacement (Without G96)



Callout Component Name

Preliminary Procedure

1. Remove the muffler. Refer to Exhaust Muffler Replacement (LAU/A28NER) Exhaust Muffler Replacement (Spare part) Exhaust Muffler Replacement (LBY/A20DTR) Exhaust Muffler Replacement (LBS/A20DTH) Exhaust Muffler Replacement (LHU/A20NFT, LLU/A16LET)

2. Remove the propeller shaft. Refer to Propeller Shaft Replacement .

3. Remove both rear wheel drive shafts. Refer to Rear Wheel Drive Shaft Replacement

4. Remove the bushing bolts and move aside the stabilizer shaft. Refer to Stabilizer Shaft Replacement (GNC) Stabilizer Shaft Replacement (GNE FWD) .


1

Protective Cover


Procedure

1. Unhook the protective cover from the hydraulic pump.

2. Undo the cable clips.

3. Remove the electrical connection.


2

Rear Axle Assembly Bolts (Qty: 4)

Warning

To prevent personal injury and/or component damage, support the differential case when removing the case from the axle housing. If the case is not supported, the differential case could fall and cause personal injury or damage to the differential case.


Refer to Fastener Caution .


Procedure

1. Support the rear axle with a column jack.

2. Secure with cable ties.

3. Lower the differential clutch assembly.

4. Use new bolts


Tighten

90 Nm (66 lb ft) + 90 degrees + 15 degrees

3

Rear Axle Assembly Bolts (Qty: 4)

Warning

The hydraulic pressure in the differential clutch is very high. To prevent personal injury, wait for at least 10 minutes before removing any parts from the differential clutch.


Tighten

30 Nm (22 lb ft)

4

Rear Axle