SAAB WIS ONLINE

Brake and Accelerator Pedal Assembly Replacement (Right Hand Drive)

Brake and Accelerator Pedal Assembly Replacement (Right Hand Drive)



Callout Component Name

Preliminary Procedure

1. Remove the front floor console, refer to Front Floor Console Replacement

2. Remove the Instrument panel outer trim cover, refer to Instrument Panel Outer Trim Cover Replacement - Right Side

3. Remove the windshield side garnish moulding, refer to Windshield Side Garnish Molding Replacement

4. Remove the front and rear side door sill trim, refer to Front and Rear Side Door Sill Trim Plate Replacement

5. Remove the power vacuum brake booster. Refer to Power Vacuum Brake Booster Replacement (Left Hand Drive) Power Vacuum Brake Booster Replacement (Right Hand Drive) .

6. Remove the steering column. Refer to Steering Column Replacement

7. Release the bonnet release handle. Release the instrument panel tie bar, lift it out and secure the tie bar approx. 40 mm out, on the left side of the car. Refer to Instrument Panel Tie Bar Replacement .


Note

The fasteners to the pedal assembly need to be removed before the tie bar is released.


1

Brake and Accelerator Pedal Assembly Fastener (Qty: 8)

Refer to Fastener Caution .

Tighten

22 Nm (16 lb ft)

2

Brake and Accelerator Pedal Assembly


Procedure

1. Disconnect the electrical connectors.

2. Install NEW click fit connector on brake pedal arm.