SAAB WIS ONLINE

Control module

Control module

Removal

Before starting work, read the .

Warning

Read the Safety and handling instructions before starting work.



1. Remove the negative lead from the battery.

2. Remove the rear section of the centre console. See section 853 in Service Manual 8:2 Interior equipment.

3. Unplug the control module connector.

4. Remove the nuts securing the control module.


Fitting


1. Fit the control module in place and tighten the nuts.

2. Plug in the control module connector.

3. Refit the rear section of the centre console. See section 853 in Service Manual 8:2 Interior equipment.

4. Refit the negative battery lead.

5. Connect the ISAT to the data link connector under the facia and erase any diagnostic trouble codes.

6. Start the engine and check that the SRS lamp comes on for about 3-4 seconds and then goes out.