SAAB WIS ONLINE

The SRS lamp comes oncontinuously immediately after ignition turn-on.

The SRS lamp comes on continuously immediately after ignition turn-on.

No diagnostic trouble code, no contact with the system



1. Check fuse 25.

2. Unscrew the steering wheel airbag and unplug the connector at the back of the airbag. Connect reference resistor 84 71 153 to the connector.


On cars with a passenger airbag, remove the glove box and unplug the connector on the undenrside of the airbag. Connect reference resistor 84 71 153 to the connector.

3. Unplug the connector at the control module and check pin 9 for open circuit/slide-out.


Close the connector and switch on the ignition.

If the lamp does not come on, the fault was in the connector.

If the lamp is still on continuously, proceed to point 4.

4. Unplug the connector at the control module and connect a BOB to the connector on the wiring. Switch on the ignition and take a voltage reading across pin 9 and a good grounding point.


If no battery voltage is present, check the wiring connected to fuse 18 for open circuit.

Rectify the fault.

If the reading obtained is 9 - 16 V, proceed to .