Differential bearing race in clutch case.
Differential bearing race in clutch case. |
Condition: gearbox removed from car
1. |
Remove the four screws of the seal holder. Lift out the screws and the seal holder and remove the O-ring.
|
2. |
Carefully tap out the bearing race with a hammer and a drift (destructive removal).
|
Fitting |
1. |
Fit (press) the new bearing race in place as far as it will go, using tools 87 91 246 and 87 91 204.
. Use support 87 92 236
|
2. |
Refit the seal holder with its O-ring. Tighten the screws alternately.
|
Tightening torque 22 Nm (16 lbf ft).