SAAB WIS ONLINE

Ignition lock with ignition lock switch

Ignition lock with ignition lock switch


To remove


1. Remove gear lever housing as described in Section "Gear lever housing".

2. Remove the locking plate holder.

3. Remove the spring that holds the locking plate.

4. Using a screwdriver snap out the rider which is governed from the ignition lock. Lift up the locking plate with its plastic fastener.

5. Remove the ignition lock switch.


6. Remove the ignition lock.


Fitting



1. Fit the ignition lock.

2. Fit the ignition lock switch.

3. Insert the locking plate. Check that the locking plate's two bearings (rubber bushing and hat) in the housing are in place.

4. Clip the ignition lock's rider into the locking plate.

5. Fit the locking plate holder. The screws which secure the locking plate holder should be coated with thread locking fluid.

6. Fit the locking plate spring.

7. Adjust the position of the locking place by means of the screw in the locking plate holder so that the locking plate is level with the shoulder on the gear-lever housing. The ignition switch should be in the “ON” position


Important

The stop may not touch the locking plate during the adjustment.


8. Fit the gear lever housing as described in Section "Gear Lever Housing".