Replacing O-ring and sealing ring in left seal holder
|
|
Replacing O-ring and sealing ring in left seal holder
|
The gearbox or the left-hand drive shaft must have been removed from the car.
|
1.
|
Remove the five screws of the seal holder and remove the seal holder by tapping with a drift from the backside. Put the shims, screws and seal holder in a safe place.
|
|
2.
|
Press out the sealing ring with sleeve 87 91 311
and support 87 92 236.
|
|
3.
|
Detach the O-ring with a small screwdriver or similar.
|
|
1.
|
Press the sealing ring on, using drift 87 90 859
and drift 83 90 312,
until it is in place. Use 87 92 236 as a counterstay.
|
|
2.
|
Lubricate a new O-ring and carefully fit it.
|
|
3.
|
Lubricate the sealing ring with gearbox oil.
|
|
4.
|
Bolt on the seal holder and shims that were fitted originally. Tighten alternately.
|
Tightening torque 22 Nm (16 lbf ft).
