Replacing sealing ring on right seal holder
| Replacing sealing ring on right seal holder |
| 1. |
Remove the seal retainer.
|
|
| 2. |
Press out the sealing ring with tool 87 91 311
and support 87 92 236.
|
|
| Fitting |
| 1. |
Press the sealing ring on until it is in place, using tools 87 90 859,
83 90 312
and support 87 92 236.
Lubricate the sealing ring with gearbox oil.
|
|
| 2. |
Fit the seal holder with the four screws. Check that the O-ring is in place. Tighten alternately.
|
|
Tightening torque 22 Nm (16 lbf ft).
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
