Airbag, driver
Airbag, driver |
|
To remove |
1. |
Ignition in OFF position. Remove the negative cable on the battery.
|
2. |
Remove the rubber plugs over the screw holes (A).
|
3. |
Remove the bolts securing the airbag, 2 pcs (B).
|
4. |
Lift out the airbag from the steering wheel and disconnect the electrical connections on the rear of the airbag (C).
|
To fit |
1. |
Connect the electrical connections to the rear of the airbag (C).
|
2. |
Place the airbag in the steering wheel and tighten the screws securing the airbag, 2 pcs (B).
|
3. |
Refit the rubber plugs over the screw holes (A).
|
4. |
Connect the negative cable on the battery and turn on the ignition.
|
5. |
Connect the diagnostic tool to the data link connector under the dashboard and clear any diagnostic trouble codes.
|
Check whether a diagnostic trouble code is shown.
If a diagnostic trouble code is shown:
Perform the relevant fault diagnosis according to the instructions in the: Fault diagnosis, general .
If the diagnostic trouble code is not shown:
Refit the items you have removed.